ATP-EL-02 · Rarely replaced
Electric motor
Part of Electrical and control system · Book 8 · § 5
Spare and wear part for concrete batching plants, in stock in Türkiye. Send us a photo and a few dimensions: an engineer checks it against your machine and you get a quote within 24 working hours.
Faults where this part may be needed
- Overload trips after runningMechanical overload, voltage unbalance, overload set too low, or blocked cooling.
- Breaker trips instantlyShort circuit or earth fault in the cable or motor.
Troubleshooting page: Motor will not start or the overload keeps tripping → Open the diagnosis →
What to send when ordering
- Photo of the nameplate or label (motor, drive, contactor, sensor, PLC module).
- Motors: kW, voltage, frequency, speed, frame size, mounting (B3, B5, B35), shaft diameter, IP rating, brake.
- Contactors and breakers: maker and part number, rating, coil voltage, auxiliary contacts.
- Drives and soft starters: maker, full model code, rating, firmware version if known.
- Sensors: maker and part number, or type, size (M12, M18, M30), sensing distance, PNP or NPN, NO or NC, voltage, connector.
- PLC modules: the full order number and the rack position.
Other parts of this section
- ATP-EL-01Main motor contactor
- ATP-EL-01.1Overload relay
- ATP-EL-01.2Control and power fuses
- ATP-EL-03Variable-speed drive / soft starter
- ATP-EL-04Inductive proximity sensor
- ATP-EL-04.1Magnetic reed sensor
- ATP-EL-04.2Mechanical limit switch
- ATP-EL-0524 V DC power supply
- ATP-EL-05.1Control relays
- ATP-EL-06PLC input / output card
- ATP-EL-07E-stop button
- ATP-EL-08UPS batteries
- ATP-EL-09Surge protection device