ATP-AB-07 · Wear part
Bin vibrator
Part of Aggregate bins · Book 4 · § 7
Spare and wear part for concrete batching plants, in stock in Türkiye. Send us a photo and a few dimensions: an engineer checks it against your machine and you get a quote within 24 working hours.
Faults where this part may be needed
- Gate opens, nothing comes outA bridge has formed over the outlet.
- Flow starts, then stopsA rat-hole collapses and re-forms.
- Only the sand bin stops, in the morningsOvernight compaction or frost.
- Vibrator has no effect on flowToo small, wrong place, or force set too low.
- Crack near the vibratorMounted on thin plate, oversize, or loose.
- Ground hopper bridgesWet or frozen sand, grid too fine, or vibrator not working.
Troubleshooting page: Bin vibrator has no effect, packs the sand or cracks the wall → Open the diagnosis →
What to send when ordering
- Bin number and the material stored.
- Gates: type (single or double clamshell, sliding), outlet size, jaw width, pivot pin diameter.
- Cylinders: bore, stroke, mounting type, rod end thread and port size.
- Solenoid valves: type (5/2, 5/3), voltage, port size, maker and code.
- Vibrators: model, force, voltage and frequency (or air pressure), mounting hole pattern.
- Liners and wear plates: material, thickness, hardness, sheet size and fixing type.
Other parts of this section
- ATP-AB-01Gate air cylinder
- ATP-AB-01.1Gate cylinder seal kit
- ATP-AB-01.2Clevis pins and rod ends
- ATP-AB-02Gate edge strips
- ATP-AB-02.1Gate pivot bushings and bolts
- ATP-AB-02.2Gate gear segments
- ATP-AB-03Solenoid valve and coil
- ATP-AB-03.1Speed control valves and silencers
- ATP-AB-04Gate limit switch
- ATP-AB-05Wear plate above outlet
- ATP-AB-06Bin liner sheets (UHMW, rubber)
- ATP-AB-08Bin level sensor
- ATP-AB-09Top grid bars
- ATP-AB-10Air filter elements and dryer parts
- ATP-AB-11Bin cover seals and hinges