ATP-AB-02 · Main wear part
Gate edge strips
Part of Aggregate bins · Book 4 · § 6.4
Spare and wear part for concrete batching plants, in stock in Türkiye. Send us a photo and a few dimensions: an engineer checks it against your machine and you get a quote within 24 working hours.
Faults where this part may be needed
- Material on the belt between batchesA bin gate is leaking.
- Trickle after the gate closesWorn gate edges, or gate not fully closed.
Troubleshooting page: Bin gate leaks, closes slowly or does not open → Open the diagnosis →
Usually replaced together
New edge strips do not seal on worn pivot bushings.
What to send when ordering
- Bin number and the material stored.
- Gates: type (single or double clamshell, sliding), outlet size, jaw width, pivot pin diameter.
- Cylinders: bore, stroke, mounting type, rod end thread and port size.
- Solenoid valves: type (5/2, 5/3), voltage, port size, maker and code.
- Vibrators: model, force, voltage and frequency (or air pressure), mounting hole pattern.
- Liners and wear plates: material, thickness, hardness, sheet size and fixing type.
Other parts of this section
- ATP-AB-01Gate air cylinder
- ATP-AB-01.1Gate cylinder seal kit
- ATP-AB-01.2Clevis pins and rod ends
- ATP-AB-02.1Gate pivot bushings and bolts
- ATP-AB-02.2Gate gear segments
- ATP-AB-03Solenoid valve and coil
- ATP-AB-03.1Speed control valves and silencers
- ATP-AB-04Gate limit switch
- ATP-AB-05Wear plate above outlet
- ATP-AB-06Bin liner sheets (UHMW, rubber)
- ATP-AB-07Bin vibrator
- ATP-AB-08Bin level sensor
- ATP-AB-09Top grid bars
- ATP-AB-10Air filter elements and dryer parts
- ATP-AB-11Bin cover seals and hinges