ATP-AB-01.2 · Wear part
Clevis pins and rod ends
Part of Aggregate bins · Book 4 · § 6.4
Spare and wear part for concrete batching plants, in stock in Türkiye. Send us a photo and a few dimensions: an engineer checks it against your machine and you get a quote within 24 working hours.
Faults where this part may be needed
No specific fault in the diagnosis yet. Ask an engineer if you are not sure.
Often ordered with
What to send when ordering
- Bin number and the material stored.
- Gates: type (single or double clamshell, sliding), outlet size, jaw width, pivot pin diameter.
- Cylinders: bore, stroke, mounting type, rod end thread and port size.
- Solenoid valves: type (5/2, 5/3), voltage, port size, maker and code.
- Vibrators: model, force, voltage and frequency (or air pressure), mounting hole pattern.
- Liners and wear plates: material, thickness, hardness, sheet size and fixing type.
Other parts of this section
- ATP-AB-01Gate air cylinder
- ATP-AB-01.1Gate cylinder seal kit
- ATP-AB-02Gate edge strips
- ATP-AB-02.1Gate pivot bushings and bolts
- ATP-AB-02.2Gate gear segments
- ATP-AB-03Solenoid valve and coil
- ATP-AB-03.1Speed control valves and silencers
- ATP-AB-04Gate limit switch
- ATP-AB-05Wear plate above outlet
- ATP-AB-06Bin liner sheets (UHMW, rubber)
- ATP-AB-07Bin vibrator
- ATP-AB-08Bin level sensor
- ATP-AB-09Top grid bars
- ATP-AB-10Air filter elements and dryer parts
- ATP-AB-11Bin cover seals and hinges