Load cell

Faults where this part may be needed

• Zero creeps slowly over daysBuild-up on the hopper or belt, or water in a load cell or the junction box.
• Zero jumps after an impact or rock fallA load cell was overloaded.
• Zero shifts after welding nearbyWelding current passed through a cell.
• One cell reads very differently from the othersFaulty cell or channel.
• Equipment damaged after a stormSurge.

Troubleshooting page: Unstable or drifting scale reading — load cells, cables and junction box → Open the diagnosis →

Usually replaced together

Fit the same model and output; check the junction box and the mounting kit at the same time.

What to send when ordering

• Which scale (aggregate, cement, water, admixture) and its capacity.
• Load cells: maker, model, capacity, rated output (mV/V), cable length and colours, mounting type, photo of the label.
• Socks: inner diameter at both ends, length, material and clamp type.
• Valves: nominal size, body type, seat material, actuator type and air pressure.
• Weighing belt parts: belt width, length and type; roller diameter and length; drum diameter.