ATP-CS-08 · Wear part
Low-level indicator
Part of Cement silos and screw conveyors · Book 2 · § 6
Spare and wear part for concrete batching plants, in stock in Türkiye. Send us a photo and a few dimensions: an engineer checks it against your machine and you get a quote within 24 working hours.
Faults where this part may be needed
No specific fault in the diagnosis yet. Ask an engineer if you are not sure.
What to send when ordering
- Screw code and serial number from the plate, the section number and which end is driven.
- Gear motor: its own nameplate, not the screw’s.
- Hanger bearing: tube diameter and shaft diameter.
- Butterfly valve: nominal size, single or double flange, disc material and actuator type.
- Top filter: maker and model, number, length and diameter of the cartridges.
- Safety valve: connection size and set pressure. Level indicator: type, probe length and voltage.
Other parts of this section
- ATP-CS-01Fill pipe coupling and seals
- ATP-CS-02Inlet shut-off valve / pinch sleeve
- ATP-CS-04Top filter cartridges
- ATP-CS-04.1Filter diaphragm valve kit
- ATP-CS-04.2Filter cleaning timer board
- ATP-CS-05Pressure relief valve service kit
- ATP-CS-06Silo pressure sensor
- ATP-CS-07High-level indicator
- ATP-CS-10Aeration pads and check valves
- ATP-CS-11Silo vibrator
- ATP-CS-12Manual slide gate seals
- ATP-CS-13Butterfly valve
- ATP-CS-13.1Butterfly valve seat and bushings
- ATP-CS-13.2Valve actuator kit
- ATP-CS-13.3Solenoid valve and coil
- ATP-CS-14Screw section (tube and flights)
- ATP-CS-14.1Hanger bearing (complete)
- ATP-CS-14.2Hanger bearing bush
- ATP-CS-14.3Screw end bearing assembly
- ATP-CS-14.4Drive head / inlet end seal kit
- ATP-CS-14.5Screw gear motor
- ATP-CS-14.6Drive key / splined coupling
- ATP-CS-14.7Inspection hatch seals